Ultrasonic cleaning machine equipment is widely used, in the process of use, sometimes equipment failure. So, how to detect the fault of ultrasonic cleaning machine? The following points can be referred to.

1、如果使用超聲波清洗機設備的時候發現某個設定位置不能夠停止而導致動作錯誤的話，要檢查升降臂相應的感應開關有沒有異常，如果有受損或者松脫情況的要處理好。

1. If it is found that a certain set position cannot be stopped when using the ultrasonic cleaning machine, which leads to action error, check whether the corresponding induction switch of the lifting arm is abnormal, and deal with it if it is damaged or loose.
                 

2、設備上下左右行程處都有安全保護裝置，如果行程超越設置機器會停止，這時候要手動復位，重新調整好行程開關或者感應片。

2. There is a safety protection device at the up, down, left and right travel of the equipment. If the travel exceeds the setting, the machine will stop. At this time, it is necessary to reset manually and readjust the travel switch or sensor.

3、如果移動架不能正常運行，限位開關會將機器制止，這時候要手動把移動架返回到正確的位置。

3. If the moving frame can't work normally, the limit switch will stop the machine. At this time, the moving frame should be returned to the correct position manually.

除了以上幾點外，其實超聲波清洗機設備出現問題的情況還有很多種，遇到問題一定要及時查找原因并解決問題。

In addition to the above points, in fact, there are many kinds of problems in the ultrasonic cleaning machine equipment, we must find out the reasons and solve the problems in time.

本文由超聲波清洗機設備廠家整理提供，希望對大家有所幫助，如想了解更多精彩內容請點擊官網：http://www.qdnggxh.com。

This article is provided by the manufacturer of ultrasonic cleaning machine. I hope it can help you. For more information, please click the official website: http://www.qdnggxh.com .